Hey guys, Kuro here! Welcome to the first part of the tutorial! Before we begin the table-making, I will have you guys to get familiar with a few terms.


    First term: [ ]


    These brackers will be used to make the commands. All the commands will be inside these guys, so pay attention.


    Second term: /


    This simple slash will be what will "close" the command. Exemple time!


    [command] text [/command]


    Very simple, right? If you still didn''t uderstood, the second [command] is the closing one, so you need to put the slash just before thecommand that you want to close, just after the first bracker, like this: [/command]. this will close the command.This story has been stolen from Royal Road. If you read it on Amazon, please report it


    Thirdterm: table


    "Table" will be the command that will be used to "open" and "close" the table. To make the exemple, I will change the brackers for theparentheses (), so that the command won''t work and I can show the command lines, ok?


    Exemple: (table) (/table)


    This will generate the table, but we are not ready yet. To begin to make the table, you will need the next term.


    Fourth term: table row (tr)


    "Table row", or tr for short, will be like it''s name, the table row. This will create a horizontal line in the table, a row. Again, I will make the exemple like the previous one.


    Exemple: (table)(tr)(/tr)(/table)


    See? It''s easy until now! Ok, next term!


    Fifth term: Table divison (td)


    This will create the "boxes" in the table rows, and it''s where you will put the text. I will go deeer in this term in the next part, since more then this will make your head hurt(probably). Also, when you put the command, like this:


    (td) (/td)


    You will have to put the text between them. Exemple:


    (td) Text (/td)


    See? Easy right? We are just beginning! Next post will be the basic table tutorial. Until next time! Hope you guys liked it!